MEMS Electrostatically Driven Coupled Beam Filter Banks.

MEMS bandpass filters based on electrostatically driven, mechanically coupled beams with in-plane motion have been demonstrated up to the VHF band. Filters higher than second order with parallel plate drives have inherent tuning difficulties, which may be resolved by adding mass-loaded beams to the ends of the array. These beams deflect for DC voltages, and thus allow synchronized electrostatic tuning, but do not respond to in-band AC voltages and hence do not interfere with dynamic synchronization.

Mechanical Synchronization of MEMS Electrostatically Driven Coupled Beam Filters.

Micro-electromechanical systems (MEMS) bandpass filters based on arrays of electrostatically driven coupled beams have been demonstrated at MHz frequencies. High performance follows from the high Q-factor of mechanical resonators, and electrostatic transduction allows tuning, matching and actuation. For high-order filters, there is a conflict between the transduction mechanism and the coupling arrangement needed for dynamic synchronization: it is not possible to achieve synchronization and tuning simultaneously using a single voltage.

Nonlinear-Based MEMS Sensors and Active Switches for Gas Detection.

The objective of this paper is to demonstrate the integration of a MOF thin film on electrostatically actuated microstructures to realize a switch triggered by gas and a sensing algorithm based on amplitude tracking. The devices are based on the nonlinear response of micromachined clamped-clamped beams. The microbeams are coated with a metal-organic framework (MOF), namely HKUST-1, to achieve high sensitivity.