Scenedesmus sp. as a phycoremediation agent for heavy metal removal from landfill leachate in a comparative study: batch, continuous, and membrane bioreactor (MBR).

Improper disposal of municipal solid waste led to the release of heavy metals into the environment through leachate accumulation, causing a range of health and environmental problems. Phycoremediation, using microalgae to remove heavy metals from contaminated water, was investigated as a promising alternative to traditional remediation methods. This study explored the potential of Scenedesmus sp.

Fouling mitigation of microcrystalline cellulose-blended poly(vinylidene fluoride) membranes in protein separation.

Modifications of polymeric membranes are necessary to improve the membrane characteristics. The composite membrane of Poly(vinylidene fluoride)_Microcrystalline cellulose (PVDF_MCC) was prepared using dimethylacetamide/lithium chloride (DMAc/LiCl) as co-solvent to dissolve the MCC in the casting solution. The prepared membrane was characterized by using the FTIR, SEM, contact angle, and the water permeates flux.

Remediation of oily-produced water from high-salinity oilfield using a low-cost, high-alumina calcium bentonite hollow fiber membrane.

Discharging improperly treated oily-produced water (OPW) into the environment can have significant negative impacts on environmental sustainability. It can lead to pollution of water sources, damage to aquatic ecosystems and potential health hazards for individuals living in the affected areas. Ceramic hollow fiber membrane (CHFM) technology is one of the most effective OPW treatment methods for achieving high oil removal efficiency while maintaining membrane water permeability.

Plant-based calcium silicate from rice husk ash: A green adsorbent for free fatty acid recovery from waste frying oil.

Driven by the urgent need for a solution to tackle the surge of rice husk (RH) and waste frying oil (WFO) waste accumulation at a global scale, this report highlights the use of calcium silicates (CS) extracted from acid-pre-treated rice husk ash (RHA) for free fatty acid (FFA) removal from WFO as conventional RHA shows limited FFA adsorption performance. A novel alkaline earth silicate extraction method from acid-pre-treated RHA was outlined. The structural and behavioural attributes of the synthesised CS were identified through BET, SEM-EDS, and XRD analyses and compared to those of RHA.

Antibiotics oxytetracycline removal by photocatalyst titanium dioxide and graphitic carbon nitride in aquaculture wastewater.

The surge in the use of antibiotics, especially in aquaculture, has led to development of antibiotic resistance genes, which will harm environmental and public health. One of the most commonly used antibiotics in aquaculture is oxytetracycline (OTC). Employing photocatalysis, this study compared OTC degradation efficiency of two different types of common photocatalysts, TiO and graphitic carbon nitride (GCN) in terms of their photochemical properties and underlying photocatalytic mechanism.

Polydimethylsiloxane/Magnesium Oxide Nanosheet Mixed Matrix Membrane for CO Separation Application.

Carbon dioxide (CO) concentration is now 50% higher than in the preindustrial period and efforts to reduce CO emission through carbon capture and utilization (CCU) are blooming. Membranes are one of the attractive alternatives for such application. In this study, a rubbery polymer polydimethylsiloxane (PDMS) membrane is incorporated with magnesium oxide (MgO) with a hierarchically two-dimensional (2D) nanosheet shape for CO separation.

Performance of Hypersaline Brine Desalination Using Spiral Wound Membrane: A Parametric Study.

Desalination of hypersaline brine is known as one of the methods to cope with the rising global concern on brine disposal in high-salinity water treatment. However, the main problem of hypersaline brine desalination is the high energy usage resulting from the high operating pressure. In this work, we carried out a parametric analysis on a spiral wound membrane (SWM) module to predict the performance of hypersaline brine desalination, in terms of mass transfer and specific energy consumption (SEC).

A Novel Tri-Functionality pH-Magnetic-Photocatalytic Hybrid Organic-Inorganic Polyoxometalates Augmented Microspheres for Polluted Water Treatment.

The severe water pollution from effluent dyes threatens human health. This study created pH-magnetic-photocatalytic polymer microspheres to conveniently separate the photocatalyst nanoparticles from the treated water by applying an external magnetic field. While fabricating magnetic nanoparticles' (MNPs) microspheres, incorporating 0.

Hybrid Inorganic Organic PSF/Hap Dual-Layer Hollow Fibre Membrane for the Treatment of Lead Contaminated Water.

Lead (Pb) exposure can be harmful to public health, especially through drinking water. One of the promising treatment methods for lead contaminated water is the adsorption-filtration method. To ensure the cost-effectiveness of the process, naturally derived adsorbent shall be utilised.

Prediction of CO Permeance across ZIF-L@PDMS/PES Composite Membrane.

The current work predicted the permeance of CO across a ZIF-L@PDMS/PES composite membrane using two different models. The membrane was fabricated by dipping a PES hollow fiber membrane in a coating solution made using PDMS that contained ZIF-L. First, flat sheet ZIF-L@PDMS membranes were fabricated to verify the role of ZIF-L on the gas separation performance of the membrane.

Reuse of waste cooking oil (WCO) as diluent in green emulsion liquid membrane (GELM) for zinc extraction.

Zinc (Zn) was identified as one of the most toxic heavy metals and often found contaminating the water sources as a result of inefficient treatment of industrial effluent. A green emulsion liquid membrane (GELM) was proposed in this study as a method to minimize the concentration of Zn ions in an aqueous solution. Instead of the common petroleum-based diluent, the emulsion is reformulated with untreated waste cooking oil (WCO) collected from the food industry as a sustainable and cheaper diluent.

Fabrication and Characterisation of MWCNT/Polyvinyl (PVC) Polymer Inclusion Membrane for Zinc (II) Ion Removal from Aqueous Solution.

Heavy metal pollution has prompted researchers to establish the most effective method to tackle the impacts of heavy metals on living things and the environment, which include by applying nanoparticles. An example is the employment of multi-walled carbon nanotubes (MWCNTs) as an additive in an intermediate membrane or polymer inclusion membrane (PIM). The MWCNTs were added to enhance the properties and reinforce the transport performance of zinc (II) ion (Zn2+) removal from the source phase to the receiver phase by the PIMs.

Optimization of CO/H Separation over Ba-SAPO-34 Zeolite Membrane Synthesized by Microwave Heating.

CO/H separation using membrane technology is an important research area in order to obtain high purity hydrogen as one source of clean energy. Finding a suitable inorganic membrane is one of the critical issues, which needs to be explored for CO/H separation. In the present study, Ba-SAPO-34 zeolite membrane was synthesized and followed by a modification process.

Gadolinium based contrast agents (GBCAs): Uniqueness, aquatic toxicity concerns, and prospective remediation.

The current toxicity concerns of gadolinium-based contrast agents (GBCAs) have birthed the need to regulate and, sometimes restrict its clinical administration. However, tolerable concentration levels of Gd in the water sector have not been set. Therefore, the detection and speedy increase of the anthropogenic Gd-GBCAs in the various water bodies, including those serving as the primary source of drinking water for adults and children, is perturbing.

Municipal Landfill Leachate Treatment and Sustainable Ethanol Production: A Biogreen Technology Approach.

Sustainable material sources are an important agenda to protect the environment and to meet human needs. In this study, sp. was used to treat municipal landfill leachate via batch and continuous cultivation modes to protect the environment and explore sufficient biomass production for bioethanol production using .

A Contrastive Study of Self-Assembly and Physical Blending Mechanism of TiO Blended Polyethersulfone Membranes for Enhanced Humic Acid Removal and Alleviation of Membrane Fouling.

In this study, membrane fabrication was achieved by two different methods: (i) self-assembly and (ii) physical blending of TiO in PES membrane for humic acid filtration. The TiO nanoparticles were self-assembled by using TBT as the precursor and pluronic F127 as triblock copolymers around the membrane pores. This was achieved by manipulating the hydrolysis and condensation reaction of TBT precursors during the non-solvent induced phase separation (NIPS) process.

Non-Solvent Influence of Hydrophobic Polymeric Layer Deposition on PVDF Hollow Fiber Membrane for CO Gas Absorption.

The implementation of hydrophobicity on membranes is becoming crucial in current membrane technological development, especially in membrane gas absorption (MGA). In order to prevent membrane wetting, a polypropylene (PP) dense layer coating was deposited on a commercial poly(vinylidene fluoride) (PVDF) hollow fiber membrane as a method of enhancing surface hydrophobicity. The weight concentration of PP pellets was varied from 10 mg mL to 40 mg mL and dissolved in xylene.

Graphene Oxide-Doped Polymer Inclusion Membrane for Remediation of Pharmaceutical Contaminant of Emerging Concerns: Ibuprofen.

The application of polymer inclusion membranes (PIMs) for the aquatic remediation of several heavy metals, dyes, and nutrients has been extensively studied. However, its application in treating organic compounds such as Ibuprofen, an emerging pharmaceutical contaminant that poses potential environmental problems, has not been explored satisfactorily. Therefore, graphene oxide (GO) doped PIMs were fabricated, characterized, and applied to extract aqueous Ibuprofen at varied pH conditions.

Removal of emerging contaminants by emulsion liquid membrane: perspective and challenges.

Emerging contaminants (ECs) originated from different agricultural, biological, chemical, and pharmaceutical sectors have been detected in our water sources for many years. Several technologies are employed to minimise EC content in the aqueous phase, including solvent extraction processes, but there is not a solution commonly accepted yet. One of the studied alternatives is based on separation processes of emulsion liquid membrane (ELM) that benefit low solvent inventory and energy needs.

Removal of Ibuprofen at Low Concentration Using a Newly Formulated Emulsion Liquid Membrane.

Ibuprofen (IBP) is a pharmaceutical product that is widely prescribed as an over-the-counter painkiller. It has been classified as a contaminant of emerging concern (CEC) that has received global attention in the search for a better wastewater separation technology. The emulsion liquid membrane (ELM) is one of the potential solutions for IBP removal from wastewater owing to its advantages, such as the ability to remove a highly soluble solute, energy efficient and tuneable formulation.

Fabrication, Optimization, and Performance of a TiO Coated Bentonite Membrane for Produced Water Treatment: Effect of Grafting Time.

The main problem usually faced by commercial ceramic membranes in the treatment of produced water (PW) is low water flux even though ceramic membrane was well-known with their excellent mechanical, thermal, and chemical properties. In the process of minimizing the problem faced by commercial ceramic membranes, titanium dioxide (TiO) nanocomposites, which synthesized via a sol-gel method, were deposited on the active layer of the hydrolysed bentonite membrane. This paper studied the influence of grafting time of TiO nanocomposite on the properties and performance of the coated bentonite membranes.

Non-solvent Flux Augmentation of an LDPE-Coated Polytetrafluoroethylene Hollow Fiber Membrane for Direct Contact Membrane Distillation.

Membrane distillation (MD) is a thermal technology for the desalination process that requires a hydrophobic microporous membrane to ensure that the membrane can maintain the liquid-vapor interface. This work aims to enhance the water permeation flux of the previously coated membrane by modifying the surface of the polytetrafluoroethylene hollow fiber (PTFE HF) membrane with a selected non-solvent such as acetone, cyclohexanone, and ethanol in low-density polyethylene as a polymeric coating solution. However, the modification using acetone and cyclohexanone solvents was unsuccessful because a reduction in membrane hydrophobicity was observed.

Microcrystalline Cellulose-Blended Polyethersulfone Membranes for Enhanced Water Permeability and Humic Acid Removal.

A novel polyethersulfone (PES)/microcrystalline cellulose (MCC) composite membrane for humic acid (HA) removal in water was fabricated using the phase inversion method by blending hydrophilic MCC with intrinsically hydrophobic PES in a lithium chloride/N,N-dimethylacetamide (LiCl/DMAc) co-solvent system. A rheological study indicated that the MCC-containing casting solutions exhibited a significant increase in viscosity, which directly influenced the composite membrane's pore structure. Compared to the pristine PES membrane, the composite membranes have a larger surface pore size, elongated finger-like structure, and presence of sponge-like pores.

Isotherm and Electrochemical Properties of Atrazine Sensing Using PVC/MIP: Effect of Porogenic Solvent Concentration Ratio.

Widespread atrazine use is associated with an increasing incidence of contamination of drinking water. Thus, a biosensor using molecularly imprinted polymers (MIPs) was developed to detect the amount of atrazine in water to ensure prevention of exposure levels that could lead to reproductive effects in living organisms. In this study, the influence of the porogen on the selectivity of MIPs was investigated.