Discrimination between washed Arabica, natural Arabica and Robusta coffees by using near infrared spectroscopy, electronic nose and electronic tongue analysis.

Background: The aim of this study is to investigate the feasibility of a 'holistic' approach, using near infrared (NIR) spectroscopy and electronic devices (electronic nose and electronic tongue), as instrumental tools for the classification of different coffee varieties. Analyses were performed on green coffee, on ground roasted coffee and on coffee beverage. Principal component analysis was applied on spectral and sensory data to uncover correlations between samples and variables.

Post-curing conversion kinetics as functions of the irradiation time and increment thickness.

Objective: This study evaluated the variation of conversion degree (DC) in the 12 hours following initial photoactivation of a low-shrinkage composite resin (Venus Diamond).

Material And Methods: The conversion degree was monitored for 12 hours using Attenuated Total Reflection (ATR) F-TIR Spectroscopy. The composite was placed in 1 or 2 mm rings and cured for 10 or 20 seconds with a LED lamp.

New-generation curing units and short irradiation time: the degree of conversion of microhybrid composite resin.

This in vitro study investigated the depth of cure of a microhybrid composite resin when cured with reduced times of exposure to three commercially available curing lights. Different sample thicknesses (1, 2, and 3 mm) were light cured in high intensity polymerization mode (2,400 mW/cm² for 5, 10, 15, and 20 seconds; 1,100 mW/cm² for 10, 20, 30, and 40 seconds; and 1,100 mW/cm² for 10, 20, 30, and 40 seconds, respectively). The degree of conversion (%) at the bottom of each sample was measured by Attenuated Total Reflection Fourier Transform Infrared (ATR F-TIR) analysis after each polymerization step.

Surface modification of Ti-6Al-4V alloy for biomineralization and specific biological response: Part I, inorganic modification.

Titanium and its alloys represent the gold standard for orthopaedic and dental prosthetic devices, because of their good mechanical properties and biocompatibility. Recent research has been focused on surface treatments designed to promote their rapid osteointegration also in case of poor bone quality. A new surface treatment has been investigated in this research work, in order to improve tissue integration of titanium based implants.