Correction: Głowacki et al. Change in the Low-Cycle Performance on the 3D-Printed Materials ABS, ASA, HIPS, and PLA Exposed to Mineral Oil. 2024, , 1120.

The authors wish to make a change to their published paper [...

Analysis of the Impact of the Post-Consumer Film Waste Scenario and the Source of Electricity on the Harmfulness of the Mass Packaging Process.

Life cycle analysis (LCA) is a popular tool for determining the environmental impacts of a product in use. The aim of this study is to carry out a life cycle analysis, gate-to-gate, of a mass packaging process using a polyethylene shrinking film with a focus on energy consumption, raw material use and associated emissions, and film post-consumer disposal scenarios. Two different scenarios for the disposal of the shrinking film used in the packaging process were analyzed, namely recycling and landfills.

An Analysis of Changes in the Harmfulness of the Bottle Packaging Process Depending on the Type of Heat-Shrinkable Film.

This article shows an analysis of selected stages of a machine's life cycle environmental impact in the specific case of machines that package bottles in thermo-shrinkable film. As part of this analysis, laboratory tests were carried out to compare the performance properties of polyethylene films (with and without recycled material). Then, a life cycle assessment (LCA) was carried out within the specified system boundaries using the SimaPro program.

Evaluation of the Effect of Mineral Oil Exposure on Changes in the Structure and Mechanical Properties of Polymer Parts Produced by Additive Manufacturing Techniques.

The paper describes the type of changes in the structure and mechanical properties of 3D printed shapes under the influence of mineral oil. The effects of a room (23 °C) and elevated temperature (70 °C) on 3D prints manufactured by the FDM method and stored in oil for 15, 30, and 60 days on the change of properties and structure were investigated. The samples were produced from ABS (poly(acrylonitrile-co-butadiene-co-styrene)), ASA (poly(acrylonitrile-co-styrene-co-acrylate), PLA (poly(lactic acid)), and HIPS (high-impact polystyrene).

Effect of Thermal Shock Conditions on the Low-Cycle Fatigue Performance of 3D-Printed Materials: Acrylonitrile Butadiene Styrene, Acrylonitrile-Styrene-Acrylate, High-Impact Polystyrene, and Poly(lactic acid).

3D printing technology is becoming a widely adopted alternative to traditional polymer manufacturing methods. The most important advantage of 3D printing over traditional manufacturing methods, such as injection molding or extrusion, is the short time from the creation of a new design to the finished product. Nevertheless, 3D-printed parts generally have lower strength and lower durability compared to the same parts manufactured using traditional methods.