Objectives: Research in adults suggests that intrusive memories and intrusive thoughts (often referred to as intrusive cognitions) are common in members of the general population and are often seen in clinical disorders. However, little is known about the experience of intrusive cognitions in adolescents, particularly in adolescents with major depressive disorder (MDD) and post-traumatic stress disorder (PTSD). The present study sought to gather fundamental data on these phenomena (i.
View Article and Find Full Text PDFPolyisobutylene (PIB) is commonly used as a primary sealant in multi-layer insulating glazing elements, where temperatures often exceed 100 °C. At such conditions, PIB undergoes structural changes, causing different relaxation dynamics and leading to decreased lifetime of the material. Understanding thermal behavior is therefore imperative for achieving effective insulation of these materials for long-term use in insulating application.
View Article and Find Full Text PDFRare earth elements are widely used in chemical engineering, the nuclear industry, metallurgy, medicine, electronics, and computer technology because of their unique properties. To fulfil ever increasing demands for these elements, recycling of rare-earth-element-containing products as well as their recovery from wastewater is quite important. In order to recover rare earth elements from wastewater, their adsorption from low-concentration aqueous solutions, by using nanomaterials, is investigated due to technological simplicity and high efficiency.
View Article and Find Full Text PDFBackground: Intrusive memories have typically been associated with post-traumatic stress disorder (PTSD) but some studies have suggested they can also occur in depression-alone.
Objective: This meta-analysis aimed to estimate the prevalence of intrusive memories in adult depression and to explore methodological and other factors that may moderate this prevalence.
Method: The databases PsycINFO, PsycARTICLES, MedLine, PubMed, CINAHL and Embase were searched for relevant articles, published up to and including July 2016.
Current recommendations advocate that blood tubes for coagulation testing should be filled not less than 90% of their nominal filling volume, since under- or over-filling >10% may generate unreliable results of some hemostasis assays. This study was hence aimed to explore filling accuracy and precision of commercial blood tubes. Between-lot variations of 3 different lots (20 tubes per lot) of 3.
View Article and Find Full Text PDF