A Porous Nanostructured ZnO Layer for Ultraviolet Sensing with Quartz Crystal Microbalance Technique.

Porous films of metals and metal oxides have gained growing attention as potential materials for use in applications that require large, specific surface areas, such as sensors, supercapacitors, and batteries. In this study, a "black-metal"-like porous Zn-ZnO composite layer was grown by room temperature co-sputtering of Zn metal and ZnO:Ga (3 at/%) ceramic targets. Following deposition, a porous ZnO layer was obtained by a subsequent thermal annealing process at 400 °C in air.

Transparent Conducting Amorphous IZO Thin Films: An Approach to Improve the Transparent Electrode Quality.

It is common knowledge that using different oxygen contents in the working gas during sputtering deposition results in fabrication of indium zinc oxide (IZO) films with a wide range of optoelectronic properties. It is also important that high deposition temperature is not required to achieve excellent transparent electrode quality in the IZO films. Modulation of the oxygen content in the working gas during RF sputtering of IZO ceramic targets was used to deposit IZO-based multilayers in which the ultrathin IZO unit layers with high electron mobility (μ-IZO) alternate with ones characterized by high concentration of free electrons (-IZO).

On the Effect of the Co-Introduction of Al and Ga Impurities on the Electrical Performance of Transparent Conductive ZnO-Based Thin Films.

In this study, a set of ZnO-based thin films were prepared on glass substrates at various substrate temperatures via the direct current magnetron sputtering of ceramic targets with the following compositions: pure ZnO, Al-doped ZnO with doping levels of 1 and 2 at.%, Ga-doped ZnO with doping levels of 1 and 2 at.%, and (Al, Ga)-co-doped ZnO with doping levels of 1 and 2 at.

The ZnO-InO Oxide System as a Material for Low-Temperature Deposition of Transparent Electrodes.

The development of optoelectronic devices based on flexible organic substrates substantially decreases the possible process temperatures during all stages of device manufacturing. This makes it urgent to search for new transparent conducting oxide (TCO) materials, cheaper than traditional indium-tin oxide (ITO), for the low-temperature deposition of transparent electrodes, a necessary component of most optoelectronic devices. The article presents the results of a vertically integrated study aimed at the low-temperature production of TCO thin films based on a zinc-indium oxide (ZIO) system with acceptable functional characteristics.

Lignin-Based Gel Polymer Electrolyte for Cationic Conductivity.

The article presents the results of the preparation and study of a gel-polymer electrolyte based on lignin obtained from . Sulfonation and subsequent chlorination of lignin make possible implementation of the principle of mono-ionic conductivity in a natural biopolymer matrix, which provides predominantly cationic conductivity of the electrolyte. Based on the results of the qualitative and quantitative analysis of the synthesized samples, the mechanisms of the chemical conversion of the biopolymer, the structure models of the converted fragments of macromolecules, as well as the quantum-chemical calculation of their electronic and geometric parameters are presented.