Perturbed Ion Temperature and Toroidal Flow Profile Measurements in Rotating Neoclassical Tearing Mode Magnetic Islands.

The perturbed ion temperature and toroidal flow were measured in rotating neoclassical tearing modes (NTM) in a tokamak for the first time. These toroidally and radially resolved profiles were obtained by impurity ion spectroscopy in a 2,1 NTM in DIII-D. In agreement with drift-kinetic simulations, the electron temperature profile is flat, while the ion temperature gradient is restored across the magnetic island O point in the presence of fast ions; the perturbed flow has minima in the O points and maxima at the X points.

Avoiding Tokamak Disruptions by Applying Static Magnetic Fields That Align Locked Modes with Stabilizing Wave-Driven Currents.

Nonrotating ("locked") magnetic islands often lead to complete losses of confinement in tokamak plasmas, called major disruptions. Here locked islands were suppressed for the first time, by a combination of applied three-dimensional magnetic fields and injected millimeter waves. The applied fields were used to control the phase of locking and so align the island O point with the region where the injected waves generated noninductive currents.

An upgrade of the magnetic diagnostic system of the DIII-D tokamak for non-axisymmetric measurements.

The DIII-D tokamak magnetic diagnostic system [E. J. Strait, Rev.

Tokamak operation with safety factor q95 < 2 via control of MHD stability.

Magnetic feedback control of the resistive-wall mode has enabled the DIII-D tokamak to access stable operation at safety factor q(95) = 1.9 in divertor plasmas for 150 instability growth times. Magnetohydrodynamic stability sets a hard, disruptive limit on the minimum edge safety factor achievable in a tokamak, or on the maximum plasma current at a given toroidal magnetic field.

Magnetohydrodynamic interference with the edge pedestal motional Stark effect diagnostic on DIII-D.

Accurate measurement of internal magnetic field direction using motional Stark effect (MSE) polarimetry in the edge pedestal is desired for nearly all tokamak scenario work. A newly installed 500 kHz 32-channel digitizer on the MSE diagnostic of DIII-D allows full spectral information of the polarimeter signal to be recovered for the first time. Fourier analysis of this data has revealed magnetohydrodynamic (MHD) fluctuations in the plasma edge pedestal at ρ ≥ 0.

Magnetic-flux pumping in high-performance, stationary plasmas with tearing modes.

Analysis of the change in the magnetic field pitch angles during edge localized mode events in high performance, stationary plasmas on the DIII-D tokamak shows rapid (<1 ms) broadening of the current density profile, but only when a m/n=3/2 tearing mode is present. This observation of poloidal magnetic-flux pumping explains an important feature of this scenario, which is the anomalous broadening of the current density profile that beneficially maintains the safety factor above unity and forestalls the sawtooth instability.

Reduced critical rotation for resistive-wall mode stabilization in a near-axisymmetric configuration.

Recent DIII-D experiments with reduced neutral beam torque and minimum nonaxisymmetric perturbations of the magnetic field show a significant reduction of the toroidal plasma rotation required for the stabilization of the resistive-wall mode (RWM) below the threshold values observed in experiments that apply nonaxisymmetric magnetic fields to slow the plasma rotation. A toroidal rotation frequency of less than 10 krad/s at the q=2 surface (measured with charge exchange recombination spectroscopy using C VI) corresponding to 0.3% of the inverse of the toroidal Alfvén time is sufficient to sustain the plasma pressure above the ideal MHD no-wall stability limit.

Multitude of core-localized shear Alfvén waves in a high-temperature fusion plasma.

Evidence is presented for a multitude of discrete frequency Alfvén waves in the core of magnetically confined high-temperature fusion plasmas. Multiple diagnostic instruments confirm wave excitation over a wide spatial range from the device size at the longest wavelengths down to the thermal ion Larmor radius. At the shortest scales, the poloidal wavelengths are comparable to the scale length of electrostatic drift wave turbulence.

Measurement of the resistive-wall-mode stability in a rotating plasma using active MHD spectroscopy.

The stability of the resistive-wall mode (RWM) in DIII-D plasmas above the conventional pressure limit, where toroidal plasma rotation in the order of a few percent of the Alfve n velocity is sufficient to stabilize the n=1 RWM, has been probed using the technique of active MHD spectroscopy at frequencies of a few Hertz. The measured frequency spectrum of the plasma response to externally applied rotating resonant magnetic fields is well described by a single-mode approach and provides an absolute measurement of the damping rate and the natural mode rotation frequency of the stable RWM.

Suppression of large edge-localized modes in high-confinement DIII-D plasmas with a stochastic magnetic boundary.

A stochastic magnetic boundary, produced by an applied edge resonant magnetic perturbation, is used to suppress most large edge-localized modes (ELMs) in high confinement (H-mode) plasmas. The resulting H mode displays rapid, small oscillations with a bursty character modulated by a coherent 130 Hz envelope. The H mode transport barrier and core confinement are unaffected by the stochastic boundary, despite a threefold drop in the toroidal rotation.

Sustained stabilization of the resistive-wall mode by plasma rotation in the DIII-D tokamak.

Values of the normalized plasma pressure up to twice the free-boundary stability limit predicted by ideal magnetohydrodynamic (MHD) theory have been sustained in the DIII-D tokamak. Long-wavelength modes are stabilized by the resistive wall and rapid plasma toroidal rotation. High rotation speed is maintained by minimization of nonaxisymmetric magnetic fields, overcoming a long-standing impediment [E.

Internal kink instability during off-axis electron cyclotron current drive in the DIII-D tokamak.

Experimental evidence is reported of an internal kink instability driven by a new mechanism: barely trapped suprathermal electrons produced by off-axis electron cyclotron heating on the DIII-D tokamak. It occurs in plasmas with an evolving safety factor profile q(r) when q(min) approaches 1. This instability is most active when ECCD is applied on the high field side of the flux surface.